Assembly — Installing the Light Kit
16
11
Attaching the light kit to
the switch housing
□ Remove the three light kit mounting screws (JJ) from
the LED light kit (J) and keep these screws.
□ While holding the LED light kit (J) under your fan
motor assembly (G), locate two single white and blue
wires in the switch housing labeled "FOR LIGHT".
Make the polarized plug connections:
- White to white
- Blue to black
□ Carefully push all wires back into the switch housing.
Install the light kit assembly (J) onto the switch
housing with the three light kit mounting screws (JJ)
removed previously. Be sure to tighten all screws.
CAUTION: Before starting the installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
12
Mounting the glass shade
□ Raise the glass shade (K) up against the LED light kit
(J) and secure the glass shade (K) to the fan by
turning the glass shade (K) clockwise until snug. Do
not overtighten.
JJ
J
G
CAUTION: Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
K
J
Commentaires sur ces manuels